Dienstag, 25. September 2018, 13:29 UTC+2

Sie sind nicht angemeldet.

  • Anmelden
  • Registrieren

Suchergebnisse

Suchergebnisse 1-7 von insgesamt 7.

Sonntag, 19. Januar 2014, 23:26

Forenbeitrag von: »vlad21«

Firmware upgrade and crash

Hi! Sorry, I was busy last few weeks... Please, help me, how can I download openwrt ( or redboot ) via serial port. I bougth a cheap usb to serial device ( http://www.ebay.com/itm/2pcs-PL2303HX-US…t-/171127768483 ). I connected my usb device to a four pins port on the NAS motherboard, but not happened nothing... Is the four pin connector the JTAG connector? What is the basic setting for serial port ( 9600 N81 )? What kind of terminal program need to use for it? I tried with realterm ( http://rea...

Mittwoch, 11. Dezember 2013, 14:00

Forenbeitrag von: »vlad21«

Firmware upgrade and crash

Hi! What did I do: MBox powered on and connected directly to my desktop with an RJ45 cable ( no cross cable ). I edited the network parameters and saved it in 'interfaces' file. " # This file describes the network interfaces available on your system # and how to activate them. For more information, see interfaces(5). # The loopback network interface auto lo iface lo inet loopback # The primary network interface # allow-hotplug eth0 auto eth0 iface eth0 inet static address 192.168.1.2 netmask 255...

Montag, 9. Dezember 2013, 21:29

Forenbeitrag von: »vlad21«

Firmware upgrade and crash

Hi! Sorry, I didn't understand, how should I set up the IP range... ?( My desktop network config is : /etc/network/interfaces " # This file describes the network interfaces available on your system # and how to activate them. For more information, see interfaces(5). # The loopback network interface auto lo iface lo inet loopback # The primary network interface allow-hotplug eth0 auto eth0 iface eth0 inet static address 192.168.0.100 netmask 255.255.255.0 gateway 192.168.0.1 " How possible to set...

Sonntag, 8. Dezember 2013, 19:25

Forenbeitrag von: »vlad21«

Firmware upgrade and crash

Hi! I hope, I found it! root@debian7kde:/home/vlad# nmap -sP 192.168.0.100-254 Starting Nmap 6.00 ( http://nmap.org ) at 2013-12-08 18:42 CET mass_dns: warning: Unable to determine any DNS servers. Reverse DNS is disabled. Try using --system-dns or specify valid servers with --dns-servers Nmap scan report for 192.168.0.100 Host is up. Nmap scan report for 192.168.0.199 Host is up (0.00023s latency). MAC Address: 00:xx:xx:xx:xx:xx (Eunicorn) [I checked this MAC. It was OK] Nmap done: 155 IP addre...

Dienstag, 3. Dezember 2013, 12:44

Forenbeitrag von: »vlad21«

Firmware upgrade and crash

Hi! Thank you for your help. What did I do: I did everything, as described you. I set up the NAS IP to a fixed IP ( 192.168.0.100 ) I set up my PC IP to 192.168.0.150 I restarted NAS and PC too, checked IPs again I swithced off all ( NAS and PC ). I pulled out the LAN cables ( NAS an PC ) from the router, and pulled out the HDD from the NAS's bay. I connected the PC directly to the NAS with LAN cable ( not cross cable ). I powered up all, and checked connection with ping command ( from terminal ...

Mittwoch, 27. November 2013, 19:44

Forenbeitrag von: »vlad21«

Firmware upgrade and crash

Hi AQUAR! I tried to change the original (ver. 1.1.1) firmware to Opengemini 1.4. I did everything step by step as you described, except, so I use fixed IP ( 192.168.0.100 ) for my Box. I pushed "Upgrade" button and I'm waiting for reboot about 5 minutes, but no action. Only three leds was on ( POWER, LAN, STATUS ), no blinks, no nothing. I pushed my Firefox's refresh button. It send something to the box ... After few seconds, all leds became on and that was all. 10 minutes later I switched off ...

Dienstag, 25. Dezember 2012, 15:05

Forenbeitrag von: »vlad21«

WDN2000 (MBox) questions.

Hi! Happy New Year to everyone! I have few questions. How possible to log in with Telnet or SSH? In terminal (Debian6 KDE): root@debian6kde:/home/vlad# telnet 192.168.0.100 Trying 192.168.0.100... telnet: Unable to connect to remote host: Connection refused root@debian6kde:/home/vlad# ssh 192.168.0.100 Protocol major versions differ: 2 vs. 1 Next. I would like to change Bit Torrent client to another one, because the original not work with magnet link(s). Next. Last summer lightning knocked out t...